Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Who do I contact for a.....

Posts

Who do I contact for a.....

#1

Who do I contact for a.....

KurtK in Indy

>longer tool post for the McNaughton coring system? I have the PM 3520 and am finding out that I'm not the only one having trouble keeping the post in the banjo and concurrently having the tool at center height.

I have heard that a longer post is available, specifically for use in the 3520. Where do I find one??

Thanks,

Kurt

Re: Who do I contact for a.....

#2

Re: Who do I contact for a.....

Wood Spinner

>If you bought at Craft Supply they will exchange with you. I had to do it also.

Good turning and be safe

Bill in Casa Grande, AZ.

Re: Who do I contact for a.....

#3

Who do I contact for a.....

Greg Jensen

>Send me your address and I will get one off to you. Please confirm for me that it is a 1" column. There have been three different sizes used on that lathe since its went into production.

Greg Jensen

North American Rep for Kelton Tools

Re: Who do I contact for a.....

#4

Re: Wish I had known about you.

Al Crandall

>I bought the coring system at Woodcraft a year ago. When I asked them about a longer support post for my PM4224 banjo, they told me that they had backorders from Kelton from 6 months prior and that Kelton didn't answer their emails. They told me to get a machine shop to make one for me, and they knocked off $25 for my trouble. The custom post cost me $50 and was fabricated from 2" dia. CRS. The larger diameter means that I have a 1/2" wide shoulder against the banjo to take the stress of the cut instead of the pressure being transferred to the banjo locking screw. The cutter is always at the exact center because the shoulder won't let it be set below center. The top end of the custom post is a duplication of the stock gate post. If I had known who you were, I could have saved myself $25.

Re: Who do I contact for a.....

#5

Ted Calver

Re: Who do I contact for a.....

Ted Calver

>Greg,

Don't want to swamp you with requests for replacement posts but, I'm in the same boat with the set I bought at woodcraft for my PM4224. Did not realize there were different posts available. Can you provide any particulars on the length of 1" posts available?

Thanks,

Ted

Re: Who do I contact for a.....

#6

Re: Folks, Greg is a...

Lyn J. Mangiameli

>tremendous resource for anything Kelton and it is well worth keeping his email address in your files. He's also the guy who is shepherding the P&N tools into North America. One of the genuine "white hats" in the woodturning world.

Re: Who do I contact for a.....

#7

Thanks everyone!!

KurtK in Indy

>