Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

P&N Gouge Report

Posts

P&N Gouge Report

#1

P&N Gouge Report

Rob in Kansas

>For those that were dying to hear...

I just recieved my 5/8" (16MM) bowl gouge. I took a set of digital calipers to the handle end. I came up with .476 inches and 12.03 MM.

I've pulled out a piece of Ash for the handle and hope to get it turned tonight or tomorrow.

Re: P&N Gouge Report

#2

Re: P&N Gouge Report

Fred in NC

>Rob:

Thank you for posting this info.

If you don't mind, when you post pics of the finished gouge, I would appreciate if you also post the overall width and width of the flute of the cutting end. Thanks !

Fred

Re: P&N Gouge Report

#3

Re: P&N Gouge Report

Rob in Kansas

>Sure Fred,

I'll get those measurements this afternoon after I get to job #2.

Rob

Re: P&N Gouge Report

#4

Re: P&N Gouge Report

Rob in Kansas

>Okay Fred,

Overall width 16MM

width of the flute of the cutting end 9MM about 1/2 way donn the flute it's 6MM. I couldn't get a good reading at the bottom.

Rob

Re: P&N Gouge Report

#5

Thank you !..

Fred in NC

>