Re: Tapered sliding dovetail
Derek Cohen (in Perth, Australia)
Oh .. I thought was very funny. 
Regards from Perth
Derek
Knowledge You Can Build On — Est. 1998
Re: Tapered sliding dovetail
Derek Cohen (in Perth, Australia)
Oh .. I thought was very funny. 
Regards from Perth
Derek
First joint
David Weaver
First joint:
Carcase dovetail test joint https://imgur.com/gallery/MV25UHr
Rather second. I cut the base too low on the first one. As bill would say, collecting data at this point.
Side note..
David Weaver
Side note..
The best saw for cutting the joint is one of those cheap hardpoint cross cut saws. The 20 inch size with huge teeth and a plastic handle. The speed of the teeth in a long partially buried cut is an asset.
Re: Skew backwards?
David Weaver
That's correct - the skew is open toward the side of the plane instead of closed. As I understand the function would be if this were a dado plane, the nicker would cut the side wall, anyway, so that is what this plane is set up to do. The end of the tail can split off (just the very tip), but most of the shelves that I have to cut yet are not cut to width (board width, not case width) so I can sacrifice that part - it could otherwise be dealt with.
My test board was poplar, which doesn't have much conviction, but it still worked well enough for this project.