Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Trouble with the bevel

Posts

Trouble with the bevel

#1

Trouble with the bevel

Joe shelton

My apologies to Mr. Eastwood.

I am not capable of cutting a decent chip with my Pfeil scorp. It's the large one with two handles, and seems to me angled wrong.

When I arrange work well below waist level, the tool is effective, but otherwise it's a scraper.

The bevel is out cannel . I'm considering grinding to an incannel to change the angle of attack.

Any comments?

Re: Trouble with the bevel

#2

Re: Trouble with the bevel

Wiley Horne

Hi Joe,

If you haven’t yet, you might take a look at Curtis Buchanan on Youtube. He shows using the two-handed scorp (or inshave), and does it standing with his arms extended, so the cut is thigh height. He also has a good scorp sharpening video on Youtube.

With the bevel on the bottom side of the cut, you can control the depth. If the bevel were on the top side of the cut, seems like the tool would immediately want to dive and come to a quick stop.

The Curtis Bichanan videos are good because they’re unedited as far as I can tell—he shows the real life of it.

Wiley

Re: Trouble with the bevel

#3

Re: Trouble with the bevel

Philip Duffy

So true, every word. Curtis B. is the master of the art of Windsors! P.

Re: Trouble with the bevel

#4

Re: Trouble with the bevel

Jim Matthews

Working at a bench or shaving horse?

Angle of attack must be balanced by what the steel can support.

(Too acute, and the edge fails - too obtuse and it won't cut.)

Re: Trouble with the bevel

#5

Re: Trouble with the bevel

Joe shelton

Jim, your's is the right question, I think. Trying to work at my bench is simply not feasible. I used my sawbench a little, and it allowed the tool to engage the work, but was clumsy.

Before I change the profile of the blade, I'm going to experiment with some sort of carving appliance that won't torture my back but still allows the edge to cut, not scrape.

Re: Trouble with the bevel

#6

Re: Trouble with the bevel

William Duffield

You might want to investigate a shaving pony, which works similarly to a shaving horse, but takes up a lot less room and is a bit easier to build, as it is attached to your bench. Google will show you several different designs.

Re: Trouble with the bevel

#7

Re: Trouble with the bevel

Jim Matthews

That's clever.

Kudos

Re: Trouble with the bevel

#8

Re: Trouble with the bevel

Jim Crammond

Joe,

In my experience, a scorp is a hard tool to get the hang of but when you do it is very enjoyable to use. It works best with a slicing cut. In other words, don't pull it straight back towards you with your hands straight across from one another. In my case, I prefer to have my right hand lead the left hand. It also is very important to work with the grain, so if you are hollowing a bowl, on the right side of the bowl, the right hand would lead but on the left side of the bowl, your left hand should lead.

The bevel should be fairly low, similar to a drawknife. 20-25 degrees works for me. Also, an out cannel bevel is easier to sharpen than in cannel, something to consider before you change it.

Jim