Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

we'll need to restart in beech

Posts

Re: we'll need to restart in beech

#26

Re: we'll need to restart in beech

Brian Holcombe

For the moment ash lumber is still attainable but I’m paying 25% more than last year. It remains a bargain by comparison to walnut and I’ve gotten 9” wide QS in heavy material without issue.

I plan to use it until I literally can’t buy it anymore.

Re: we'll need to restart in beech

#27

Re: we'll need to restart in beech

TomD

I love maple, it is one of my favourite woods. Some ash is nice, and since it is all on it's way out, time to use it all up. But I greatly prefer maple. While I don't have any trouble planing it, it will kick up, but there are ways around all that, I would sand it if it was wreaking my tools, and I had a table top to do. Sanding is inconvenient for me because I won't do it in the shop. But it has it's place. And I also have a selection of scraper planes, and hand scrapers, etc...

Re: we'll need to restart in beech

#28

outside of this test

david weaver

freehanding an iron on a coarser abrasive set to a standard of just getting a uniform edge, I think the rehabilitation time would've been about five minutes.

As warren said about it, if I was actually using it, I'd just plane it and work through it, or just throw it away.

I'm probably going to publish the findings of these tests somewhere, and the constraints in sharpening are kind of like being a beginner again and having no clue what's material and what's not (though I know that now) because I am going to publish the sharpening method along with the results - I can't stray and do what a competent person would do at this point.

Fixing defects like this are a good reminder of why i migrated to simple steel and simple stones.

When I first started and was working mostly with power tools, I really liked hard maple a lot. It takes crisp details off of power tools and doesn't have appreciable pores. It has to be faffed with to take dark stains, but I don't put dark stains on things.

Fantastic guitar neck wood quartered, too. I sand those at the last second after scraping them, though. The harshness sends the vibrations right through to the joint at the body.

I guess I should make note to mention in the appendix that nobody should make conclusions that aren't stated. In this case, I may not work with maple, but it's not like you can't do it. trying to maintain an edge standard and using a tedious prescriptive sharpening process that doesn't allow nuance and touch is a bad combination with it, though.

Outside of general holding here, the average person would hit that spot, power through it a little bit and sand the rest of the way.