Thanks John
A break from the steel discussions...
Posts
Re: A break from the steel discussions...
#27How is it done at Colonial Williamsburg?
Re: A break from the steel discussions...
#28How is this done at Colonial Williamsburg?
Re: A break from the steel discussions...
#29Re: How is it done at Colonial Williamsburg?
david weaver
https://www.youtube.com/watch?v=qTy3uQFsirk
Gouges, but much different type of rifle with the metal parts laid into the stock and no magazine to deal with.
(nor a design that was intended to be made in a factory with lower skilled labor and more machines).
(somewhere around 35 minutes the stock making starts - there is a small hole drilled from a ramrod with a flexible bit and a brace).
Re: A break from the steel discussions...
#30Stock finished and installed
John in NM
These pictures are a bit better than the in progress ones, I remembered the real camera today.




Finish is Waterlox over linseed with a touch of burnt umber oil paint.
This project was lots of fun, in spite of the inevitable little errors that aren't obvious but I know about. Shaping is probably the best part.
Re: A break from the steel discussions...
#31Re: Stock finished and installed
Wiley Horne
John,
Beautiful work! I looked up the rifle, and one thing interesting was that it is chambered for pistol rounds (various calibers) and the workaday folks in the West who carried these carbines could carry a revolver and the 92, both using the same ammunition. Something to aspire to!
Wiley
Re: A break from the steel discussions...
#32Re: Stock finished and installed
Bruce, a MN Galoot
Really good work, John! Letting in that butt plate must have been a real trial. That is not easy to do.
Re: A break from the steel discussions...
#33Re: Stock finished and installed
David Weaver
looks GREAT!
Re: A break from the steel discussions...
#34Re: Stock finished and installed
Philip F Duffy
Stunning stock and rifle! Well Done! Out of curiosity why did you chose Waterlox vice the more common rub-on varnish? P.
Re: A break from the steel discussions...
#35Re: Stock finished and installed
BrianFromMonumentCO
Nicely done.
Now after totally dry, a little wax and good rubbing out will complete the finish.
Re: A break from the steel discussions...
#36Waterlox...
John in NM
Mostly I use Waterlox because I am used to it. I've never found that the type of finish matters much if it gives you the results you're looking for, and usually there is more than one way to get those results. Any finish has strengths and weaknesses, the one you use a lot is usually the one you'll get the most out of.
I did a finish once rubbing out with pumice and rottenstone. The results were like a smooth lacquer finish without the plastic look. I may do that again as I have a Winchester 1894 that needs a stock and that would be a good one for the effort of rubbing out a finish.
Re: A break from the steel discussions...
#37Buttplate wasn't too bad...
John in NM
Spindle sander and frequent testing, like a lot of other operations you just have to sneak up on it. It was tempting to pattern rout it, but I figured it wasn't worth making the fixture for a one off.
Easy to do with a rasp too, probably easier than the sander - spindle sanders give you the illusion of automatically square and with a rasp one knows to be careful about keeping it square.
The old trick for fitting is to wipe something on the metal that will transfer to the high spots on the wood when dry fit. Black artist oil paint for example, though white works better on walnut.



