Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Kitchen cabinet molding

Posts

Re: Kitchen cabinet molding

#26

Detail question

Wiley Horne

Warren,

There will be a smooth surface off the plane. My only concern is that a sharp off-the-plane arris is a place where paint will bead (it won’t be oil paint). So my plan was to run 1-2 wipes straight down the arris with 220g.

In your experience, does paint bead on sharp arrises or no? Obviously I would just test it, but I won’t be doing the painting, and I am an incompetent painter to boot. Which is why I ask.

Wiley

Re: Kitchen cabinet molding

#27

Re: Laziness on my part

david weaver

The sanding that I've done has been generally on 6-8 foot runs of moulding that are either intended to be cut and wrapped around a case or applied in a kitchen.

I thought I was taking the easy way out (because it's intellectually lazy in my case, I took the time to make good hollows and rounds that are new and tightly fitted and can take a thin shaving without issue), but it turned out to be more trouble than it was worth, and then it could be easily spotted - which I didn't expect.

Everything finished off the plane always looks sharper, no matter how careful I've been sanding something like a moulding or door panel - you can still always see it.

Re: Kitchen cabinet molding

#28

Re: Detail question

Warren in Lancaster, PA

I do a dust rag test on carvings. Sharp edges or corners on leaves or flowers create a problem for the person who has to dust carvings. So I run a rag over a carving and note where the rag gets snagged. Those corners get doctored with a gouge, or a wooden burnisher, or 320 paper. It takes very little to make a difference for the rag and does not show up as a noticeable reflective surface.

You can use a small piece of walnut just to run down the edge, or 320 paper. You don't have to work hard.

Re: Kitchen cabinet molding

#29

Will do.  Thank you.


Re: Kitchen cabinet molding

#30

Re: Thanks for your contributions, Warren

david weaver

Perhaps the dust rag test is a common thing, but those of us who don't do professional work appreciate seeing tips of yours like that. I don't know that I'd have thought of it, and I'm sure I have case mouldings that would snag a rag in spots.