Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Old hand saws

Posts

Re: Old hand saws

#26

Re: Bob Smalser

Charles

How are you finding saws that have lost their tension to practice on, or are you hammering the tension out and then putting it back in?

I'd honestly love to see a video on that, especially if you could capture the 'floppiness' after having taken all the tension out and then the stiffness after putting it back in. A before-and-after if you will.

I had that in mind with regard to Bad Axe, but it would obviously be highly unlikely they'd do that, though it would make a hell of a marketing piece wouldn't it - if they showed one of their newly made saws before it was hammer tensioned and then after.

Re: Old hand saws

#27

Chris Scholz

Re: Old hand saws

Chris Scholz

After a it more point around on the web, I must admit you are correct and I was wrong.

There’s a fair amount of academic work in tensions circular saw blade where the autors clearly show that tensions has an effect on the behavior of the blades.

I stand corrected.

Re: Old hand saws

#28

Re: Old hand saws

Steve Voigt

Chris, props to you for changing your mind--it's not something people do a lot of on forums and the like.

A couple general comments:

I don't have nearly as much experience with saws as Dave does, but I have--once--had the misfortune to sand through a saw plate to the point where the surface tension disappears (as Dave described earlier). The effect is dramatic and almost has to be experienced to be believed. One minute, the plate is like a piece of spaghetti that's been cooked for 30 seconds--it is just barely flexible--and a few strokes of abrasive later, it's like an overdone noodle with no integrity at all. It doesn't happen gradually, it happens in one shot when you go too far. Anyone who tries it (and I don't recommend it, by the way) will instantly be convinced of the effectiveness of hammer tensioning.

I also had modest success retensioning that same plate. I would put the "modest" part down to my lack of experience, and not any lack of effectiveness of the procedure. I've definitely had some success straightening saw plates

As others have mentioned, Mark at BadAxe tensions saws. He's posted some clips on Instagram. I suppose anyone who really wanted to learn the art could go take a workshop with him.

Re: Old hand saws

#29

Surface tensioning

Bill Houghton, Sebastopol, CA

What you describe sounds like the structure of tempered glass, which similarly goes from its tempered state to its exploded state in an instant, when the surface tension is breached. I find it interesting that the two materials would behave in analogous ways.

Re: Old hand saws

#30

Good show, Chris!


Re: Old hand saws

#31

Re: Old hand saws

David Weaver

Thanks for circling back with your findings. Such a thing is rare these days.