Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Coping saw handles

Posts

Re: Coping saw handles

#26

Re: Coping saw handles

david weaver

I have been, too, but I'm more careful now that I'm further down the road. Careful meaning I'll still spend in primo stuff, but only if it delivers something and also has residual value.

This discussion triggered me to go out and get a deep/long reach vintage coping saw, though - total cost of $24 or something with shipping. Something I'd like to have. The one I found is a little bit brown, but that can be rectified.

Re: Coping saw handles

#27

Re: Coping saw handles

Brian Holcombe

Awesome, curious to see how is does.

Re: Coping saw handles

#28

Side question for steve...

david weaver

because, I'll admit, I"ve always been lazy about coping saws, despite using them a lot. I think I have one made by zona, as well as a cheapie from home depot, and i've used both. They don't have zooming tension, but I kind of like that.

i'll duck after I say this, but i sharpen coping saw blades - it removes a bit of the set, but they seem to be improved - and then they work well in brass, too. If they don't break and I've clapped them out, I cut japanese stones with them until their teeth are rounded over (same with hacksaw blades).

Anyway, I looked around and see that eclipse still seems to make a decent frame with a common-looking handle, but it's $18. Is there anything wrong with the eclipse saw?

Sears used to sell a decent looking saw made of flat bar, but they no longer do. It was 93541 - I see it being resold, but it's not in stores. At $10, i might've sprung for that, too, but not $10 plus $10 shipping like it is everywhere NOS versions are listed.

(

Re: Coping saw handles

#29

Re: Side question for steve...

Steve Voigt

Hi Dave,

I've never used an eclipse saw. IIRC Warren has a vintage one, which is probably not the same as the ones they sell.

I suspect most of the saws on the market are pretty much the same. FWW did a review a while back. It's paywalled, but scrolling through the individual entries, it looks like the LV scored a little higher than most, also the Fat Max got pretty good marks.

Re: Coping saw handles

#30

Re: Coping saw handles

Brian Holcombe

Rather than learning to cope with hand pain (Is it still unfunny if I laugh at my own jokes :D :D :D ):

The ferrule started life as a compression fitting. I retained the internal threaded portion and simply threaded the handle and provided a step for the material to compress at the top of the fitting. I turned the brass along with the handle, the material doesn't turn very well since it is a very hard brass but I made due.

The handle is cherry, which would normally be an odd choice for a handle but some unknown reason this particular cherry cuts like granite.






It's not on permanent like just yet, I dont actually own epoxy so I have to go buy some.

Re: Coping saw handles

#31

Re: Coping saw handles

Hank Knight

That's a great retrofit, Brian! Got me thinking about doing mine.

Re: Coping saw handles

#32

Re: Coping saw handles

Brian Holcombe

Thank you!