Re: tips for deep mortises? I don't want to pry...
TomD
It can be worth exploring techniques for mortising that do not require prying. One doesn't cut down a tree by directing the axe blows so haphazardly that the chips need to be pried out. And the principle with mortises is the same, each chip is undercut in an order that it releases. It is a little slower for shallow mortises though, as one has to switch the bevel back and forth. I learned this as a Japanese method (doubtless universal), but it is how the old pedal operated mortisers with the single bevel chisels worked, so as western as steak.
However, having had to make the odd 2 inch mortise that was 1/4" wide and 8 inches deep, the drill is your friend. I saw a classical Japanese carpenter do a mortise with an auger once, also, so it may well be traditional. In that case on mortises traditionally, with the chisels setting the wall dimensions, the meat simply comes out with the auger. The chisel cuts perp to the grain, with the chisel sides shearing the wall cuts. The Japanese chisel's 90 deg side angles are sharpened as precisely as the edges are. That is an aside, as for really deep mortises I use a record chisel that has a very long blade. If I am using machines, I use the hollow chisel mortiser to come at the mortise from both sides. Then I use a doweling jig, to steady an extension bit of the right size, then I get the leftovers out with the deep chisel. No prying is used in the method either.