Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Wood and steel wear *LINK*

Posts

Re: Wood and steel wear *LINK*

#26

Heat

Bill Tindall, E.Tn.

If heat had any role in dulling hand planes there would be a path beat to high speed steel blades.

If anyone thinks they are heat altering a blade, plane slower and see if you can tell the difference.

Re: Wood and steel wear *LINK*

#27

Re: Nicker Burn (is that like liar liar..)

Joseph Piotrowski

rusty iron reacts with the tannin in oak and turns it black.

Re: Wood and steel wear *LINK*

#28

Re: Wood and steel wear

Dennis

I know of 4 very effective, and ancient methods for dealing with hard, ornery woods.

Water, as long as you are working the wood, it is not soaking in, it just softens the top layer, this is specially useful on end-grain.

Toothing blades can be used in any direction, and on any wood, I have seen tooth marks on work from the early 1600's.

A burnisher can be used to work-harden a sharpened edge.

My personal favorite, which is great for tropical woods.

Using the blade directly off of the grinder, the burr acts like a tiny tooth, and saves tons of time sharpening.

Re: Wood and steel wear *LINK*

#29

Re: Nicker Burn (is that like liar liar..)

David weaver

I wonder how much tannin is in beech.

Re: Wood and steel wear *LINK*

#30

Wetting the surface

GolfSteve in Calgary

I've also used low odour mineral spirits instead of water to assist planning of very difficult wood. It works very well and since you're not adding water to the board there is less tendency to warp and your plane doesn't rust.

Re: Wood and steel wear *LINK*

#31

Re: Single Irons

Brian Holcombe

I think the low bedding angle must be a factor in the longevity. I made a 45 degree bed for the same blade and certainly it wears out quicker.

I've been in a tangent with these single iron planes after one of my Facebook friends started cutting some crazy ones with a 2mm blade opening (space between the wear and the tsutsumi. I haven't managed that yet, but it's been a fun tangent.

Re: Wood and steel wear *LINK*

#32

Re: Heat

Warren in Lancaster, PA

I have done a lot of repetitive experiments for the forum over the years, but deliberately messing up an iron that is working nicely is not my cup of tea.