Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Chagrined

Posts

Chagrined

#1

Chagrined

Joe shelton

Finally decided to try sharpening a saw yesterday. Started with a 9 pt Disston Townsman, so that I'd not be ruining an heirloom. Filed it rip, and it worked so well that I picked up a grungy Disston Junior and embarked on a crosscut attempt. More tedious, but I was feeling good. Dialed in a new saw set, set the teeth, and was surprised at how quickly and smoothly that went. When I started a test cut, all was well. Briefly. Quickly was binding badly.

The saw set I have is adjusted with a dial marked, not according to number of teeth, but an arbitrary scale in which a large number yields a very small degree of set.

At least I found out before I discarded both the poor little saw and the bassackard saw set...

Re: Chagrined

#2

Ellis Walentine

Change the set?

Ellis Walentine

If the saw binds, you can play with the set to give you the clearance you need. It might not be much at all.

Ellis

Re: Chagrined

#3

Re: Change the set?

Joe shelton

Yes, thanks. I plan to try that this weekend. Just groping my way thru...

Re: Chagrined

#4

Re: Change the set?

Jim Matthews

If the setting tool is fiddly, the same process can be done with a fine nail set, light hammer and a backing block.

The plate must be raised off the bench high enough to get the handle clear of the surface.

I've done this in a pinch, and it works.


img

Re: Chagrined

#5

Re: Change the set?

Joe shelton

Thanks, Jim. I may try that on the next one.

Joe