New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

diamond paste question

Posts

Re: diamond paste question

#26

Re: questions for Bill

John in NM

Years ago I knew a guy who made petrographic thin sections. He had two 24" iron laps that spun and were contained in a large sink. He had two polishing grits of diamond in big shaker bottles and didn't seem to worry about contamination much as he could flush the whole thing with large amounts of water.

My conclusion from watching him work was that diamond does not embed easily in iron. Rinse it well before charging (1 lap or plate for each grit) and it should be fine. --- BUT --- he was not using anything to press the diamond grit into the laps, as I believe most people do for honing, and he was not using oil for lube, so water flushing worked well.

Another BUT - the petrographer might actually be less fastidious about the polish of a thin section than the woodworker is about a chisel! :D

(the humor actually probably won't work without knowing a few petrographers - they are typically fussy people).

Re: diamond paste question

#27

Tablesaw tops

Frank D. in Montreal

I got an old tablesaw top with a few dings but still a nice surface, and cut it up with a sabre saw. I could get at least 10 3 x 10" plates if I cut up the whole thing (I have three plates). The only inconvenience is the ribbing on the underside, you need to build some kind of support so it doesn't wobble (IIRC Derek Cohen has a tutorial on this). Total cost: $0

Re: diamond paste question

#28

Re: Tablesaw tops

Edward in Vancouver

Saw a tutorial a few years back where someone took a junker #6 plane, sawed the toe off at the mouth, epoxied it upside down into a wood block, and used that as a cast iron plate for diamond paste. Can't remember who it was though....

Re: diamond paste question

#29

Re: Tablesaw tops

Chuck Bjorgen

That sounds like Derek Cohen's tutorial. Unfortunately I don't have any junker planes at my disposal. One thing I learned from this thread is that my $8 eBay purchase of the diamond paste may have been for lesser quality product. I'm keeping Bruce's suggestion of Minnesota Lapidary Supply bookmarked if I need better stuff.

Re: diamond paste question

#30

Re: Tablesaw tops

TomD

Maybe, but since I just use the single grit with great results I would at least try it out. If it works it works. If you use it typically it may be a while before you need a refill.

Re: diamond paste question

#31

Jack Guzman from Maine

Re: Tablesaw tops

Jack Guzman from Maine

I had a useless broken #7. I cut it into three pieces. Cut off a little excess metal on the top sides and I ended up with three useable cast plates.I could mount them like Derek did but they work fine as is.---Jack

Re: diamond paste question

#32

Re: answers, thoghts and opinions

TomD

Just bolt them down to the shaper and switch them on.

I can't add anything to what Bill said, except if there was only one grain of larger media it would have it's head up so it might be pulled out by a passing blade. The overall principle is based on the idea that the blade is harder than the plate, and all the granules are very closely sized.