New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

How whould pins be shaped on a mortise gauge

Posts

Re: How whould pins be shaped on a mortise gauge

#26

Re: Simple fix

William Duffield

That's what the ¿optional? shaft clamp, 05N70.05, for the Veritas gauge does. Because of the spacing and shape of the Veritas shafts and the resistance in the head, pinching them together to hold a setting doesn't work very well.

Several years ago, I went into Hida Tool in Berkeley to learn how to use a kama kebiki, but the sales person couldn't explain its operation to me any better than I had already figured out, so I left without buying one. :( If my brain had been engaged, I would have just bought it, trusting that it had to make sense, since the Japanese had been using it successfully for hundreds of years, and I could figure it out when I got home. It was a disappointing day all around, as I had also planned to visit the bonsai garden at Lake Merritt in Oakland, but it was closed that day. :(

Re: How whould pins be shaped on a mortise gauge

#27

Re: I'm confused

TomD

"I had to look up what a Japanese gauge looked like. I bought one from Lee Valley with off-set "knives" and sent it back. Marking mortises with one knife trailing the other by a cm was too difficult for me to deal with."

Probably answered, but you use them like two separate gauges that just happen to be set up on one fence. You mark one side, then the other. I prefer actually using two gauges.

Re: How whould pins be shaped on a mortise gauge

#28

Re: I'm confused

William Duffield

I prefer actually using two gauges.

Why? What are the advantages of using two separate gauges? I can think of several reasons why I find a dual gauge to be preferable, but the only advantage of two gauges is they are simpler to make, and if you just count parts, even that is debatable. To mark one mortise you have to pick up one tool, use it, set it down, pick up another tool, use it, and set it down. They take up more room on your bench and in your tool cabinet. You can't tool slave, by setting the blades directly off the width of your mortise chisel.