New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Continuous Arm Settee build

Posts

Re: Continuous Arm Settee build

#26

Re: Last Continuous Arm Settee build

Kevin Adams

Hi Jack,

Thanks so much for taking the time to post this, you really did a great job! I have built several chairs, in classes and on my own, and I always learn something each time I see someone else's work. I had not seen fitting the spindle "upside down" like that and will definitely try that next time. I have always fit them as they will be in place, which can be time consuming as you remove the arm. Is that something you figured out or from Curtis' videos? I need to watch those one day!

A couple of questions if you don't mind...what do you use for a hand reamer, the same one you use for the legs? I've also seen small violin maker reamers (I think that's what they called, for the pegs). Secondly, do you drill the spindle holes with brace and bit (spoons?) or a cordless drill?

Thanks again, would love to see the finished product after you paint. Out of couriosity, where abouts are you in ME? I am up there fairly often (I'm in CT).

Take care,

Kevin

Re: Continuous Arm Settee build

#27

Jack Guzman from Maine

Re: Last Continuous Arm Settee build

Jack Guzman from Maine

Hi Kevin, when I build a continuous arm chair I usually fit each spindle the way it normally goes with the arm off the chair but seeing there were so many spindles I found this method to be easier.

I drill the holes in the arm with a 5/16" kreg pocket hole stepped drill bit in a cordless drill. It makes a clean hole that doesn't blow out when it comes through. Also the small pilot tip makes it easier to orient the bit on the outside holes that are drilled into a curve on the arm. Either Curtis or Elia Bizzarri discovered that bit. I don't remember which.

I highly recommend Curtis' videos to anyone who is interested in Windsor chairs. He is an excellent teacher.

I use a small hand held reamer on the arm holes. I've tried doing it with my seat reamer but the arm is only 7/16" thick here and the other reamer is just too large to be practical. I found the bit at a flea market somewhere and made the handle for it.


Where I live is a little town called Newfield on the New Hampshire border almost straight inland from Portland.---Jack

Re: Continuous Arm Settee build

#28

Re: Last Continuous Arm Settee build

Kevin Adams

Hi Jack,

Thanks for yet another tip, I am going to try one of those Kreg stepped bits, great idea! I also agree on the benefit of the small reamer as the leg one can be way too aggressive.

I will definitely watch the Curtis videos. I built a continuous arm chair with Pete Galbert a year or so ago and really enjoyed that experience. Probably the best class I've ever taken period.

I haven't been over your way in ME yet, I am water guy so pretty much hug that coast as much as I can!

Thanks again for sharing your work, good stuff!

Take care,

Kevin

Re: Continuous Arm Settee build

#29

Jack Guzman from Maine

Re: Last Continuous Arm Settee build

Jack Guzman from Maine

I envy you,working with Peter Galbert. He's another one who I follow closely. I got alot of pointers from his blog. I've even emailed him a technical question and he responded. He makes some beautiful chairs.

There isn't much up my way but pretty woods. Lots of water but no salt in it.Just lots of fish.---Jack