New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

A few tape measures

Posts

Re: A few tape measures

#26

Tapes get little use ...

Hank Knight

... in my shop except for long/rough dimensions. I never have been comfortable with their accuracy and I find them hard to mark from accurately. I much prefer flat, rigid rules, of which I have many favorites, starting with my adjustable squares (4" double, 6" combination and 12" combination). Next is my favorite and most used, a 24" satin-finished blade from a Mitutoyo combination square. I use it all the time for layout and machine set-up. Finally I have a very nice 48" stainless steel flat rule with Imperial and Metric graduations. These take care of 99% of my measuring and layout needs.

I also use two calipers for very accurate measurements. One is an inexpensive fractional dial caliper that I use all the time, especially for measuring stock thickness and similar tasks. The other is a Starrett digital machinist's caliper in thousandths (can be changed over to metric with the push of a button) that I use when I need that kind of accuracy. I find the dial caliper much easer to use because I can look at the dial and tell immediately if the measurement is over or under the target without having to do any math in my head (or on paper) like I have to do with the digital caliper.

I learned to use and appreciate the metric system in college (I was a chemistry major). I am comfortable using it, but I almost never do in woodworking. Almost all of my tools, machines, plans, fasteners and just about everything I use is calibrated or sized in Imperial units, so metric adds a complication. I've used Imperial all my life so I'm very comfortable with it. I can do most fractional calculations in my head and I visualize things in Imperial units. I would be perfectly comfortable using metric, but I don't think that's going to happen in my lifetime.

Re: A few tape measures

#27

You're all wimps

ian neuhaus

I know I'm a bit late to the discussion ...

(humor)

Metric, 16th, 32nds, 64ths, decimal inches - bah

You really should be working in decimal feet !

(serious)

like Derek I was educated in both feet and inches and metres.

where I depart from Derek is during my working life I've worked with plans in feet and inches, metric and decimal feet -- in one instance I had to convert a survey done in feet into a set of metric plans, in another the plans were a mix of decimal feet and metric and the materials being used were all metric

Unlike Derek I detest metric / imperial rules -- especially the 12 inch ones. What I hate is that you can't measure metric from both ends, because 12 inches is 304.8 mm

Re: A few tape measures

#28

I had a decimal feet tape measure once...

John in NM

We measured drill core in 0.1' increments, for a while I was always wearing it around. Used to drive a friend of mine who had a woodshop crazy since it looked just like his "normal" tape and I would hand it to him to measure something :D

Re: A few tape measures

#29

Have also used that party trick

ian neuhaus

and agree it's lots of fun watching the other person think they're measuring in 10ths of an inch, till the foot mark arrives at 10 "inches".

our plans used to be drawn to an accuracy of 1/100 of a foot -- roughly the same as 1/8" or 3 mm.

(for the pedants)

1/100 of a foot is exactly 3.048 mm (even more than 40 years later, this conversion is still firmly etched in my memory) and 1/8" is 3.175 mm (normally rounded to 3.2 mm)

and

if you want an approximate metric to imperial conversion, 2 mm equals 5/64" ths. (the error over an inch is less than 8 parts in 1000 -- feeler gauge territory)