Question: Sources for Brass Handsaw Screws?
Christopher Fitch Memphis
So I'm working on a Disston D-8 Handsaw rehab(I've narrowed the construction date down to between 1928-1940). I picked it up for $4 at an estate sale. I expect many people would have not picked it up but it was cheap and it's not in that bad of shape.
The blade was covered in rust/dirt but it cleaned up ok (certainly good enough to use) and the handle was intact but it only had the medallion and two screws.
I did a pretty thorough search looking for brass screws from lots of tool suppliers, but I just have not found anything. I can find brass split nut screws for backsaws but none for handsaws other than nickel-plated ones.
I've tried two separate sets of Disston screws off of Ebay, but those are either nickel plated for a backsaw or brass plated and the plating is almost gone.
I really don't care that much about authenticity but I do want brass and I do want some that fit!
I have no desire nor the tools to make some and Chicago screws I find online lack the crucial square part of the bolt that locks the screw in place in the handle.
Any one have any ideas?
P.S. I'll post a few pics when I'm done with it. Going to try to fix the kink Bob Smalser style and then take a shot at sharpening it. Assuming I can make all this work, it will be a good 26" 8 point crosscut saw.

Here's what it looked like at the start:







