Re: Ti Hammers
TomD
I am going to throw up some pictures of my hammers and mallets in the next day or two. Since the thread has hammer content, I will put up some pictures of framing hammers for the fun of it.
I used to make golf clubs, and when the Ti clubhead fad came about, the ti hammer fad followed, and I was prepared to smell a rat. Ti drivers were lighter than steel or wooden ones, but only slightly, and to maintain the same swingweight as drivers with shorter shafts, ti drivers were normally made a little longer, hence the lighter heads.
Ti framing hammers were 1/3rd the weight off, 14 oz generally, rather than a typical 21 for steel. Yet the claim was made that they drove nails just as well as the heavier steel framers. Not to go into all the details, I ran some numbers to determine what additional swing speed would be necessary to keep the energy on impact consistent. And to determine how easy it would be to develop that speed I compared it to the swing speed of top golfers. Just upping speed is way more difficult than one might think, and you can hook or slice nails as well as golf balls.
Interestingly, at the time the US open had just been won by a short hitter, and his average drive distance was 240 yards, which was the average drive distance of a zero handicap player at the time. At that point a long hitter on the tour was 270ish, and the longest would be around 305 (assumes placement in the fairway). The difference required to hit the ball 270 over 240, or 302 over 270, was very nearly identical to the speed increase required to hit a nail as hard with a 14 ounce hammer as a 21 ounce hammer. Which is to say "non-trivial".
Hey, you have to think of something.



