New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Building Wegner's "The Chair" - a start

Posts

Re: Building Wegner's "The Chair" - a start

#26

Jack Guzman from Maine

I don't get it

Jack Guzman from Maine

Tom,

I'm missing something here. I don't understand how that is adjustable at the right end. How does that L shaped bolt attach to the tailstock? The way I'm seeing it, the only adjustment is in and out on the left side by moving the banjo.---Jack

Re: Building Wegner's "The Chair" - a start

#27

Re: I don't get it

William Duffield

The photo on the previous page shows the tool rest with the sliding tail stock end support.

I still prefer the two banjo solution, since it allows adjustment of the distance between the rest and the work at both ends. You might also consider drilling multiple holes in the tail stock end of the tool rest, so you can adapt the same tool rest to different length spindles. Making the head stock end adjustable isn't as useful, since the head stock and often speed controls will interfere with that end of the tool rest. There are also a pertinent discussion or two going on over on the Turning forum.

If you want to inset a durable steel contact surface into your tool rest, Enco sells 1/4" diameter round hardened M2 HSS tool bit blanks in 8" lengths, currently at an inexpensive $3.42 each. Epoxy them into a wooden rest or weld onto structural steel angles.

http://www.use-enco.com/CGI/INSRIT?PARTPG=INLMKD&PMPXNO=941073&PMAKA=383-7015

These are also easily made into round detail skews.

Re: Building Wegner's "The Chair" - a start

#28

Re: I don't get it

Tom

I think it is mainly adjustable by drilling additional holes in the wooden rest. But if you have holes every few inches, you could make the fine adjustments with the banjo. I think the double banjo rest might be better, if you were turning a lot of stuff the same length, where the expense of the rest and the additional banjo were worth it. The advantage to the Conover system is that it works for any length you like, for cheap. It can do pro grade work, but isn't for constant rest fiddlers. Rest fiddling to get the best support makes a lot of sense if the rest is really easily adjustable, but it isn't necessary.

As to how the J hook attaches, the tailstock is flat on the inside surface, and there is a part of the casting that is raised, and tube like, about 6 inches bellow the center. This is threaded, and the J just threads right in there. The same effect could be achieved by silver brazing a connector nut, or two, to a tailstock not so equipped.