New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

convert transitional jack to panel raising plane?

Posts

Re: convert transitional jack to panel raising plane?

#26

Re: chip breaker

Lars Parrington

Steve, you're correct about the corners of the chipbreaker not contacting after grinding. I did bend them down, and then lapped the area on a diamond stone to bring everything into the same plane.

Getting the chipbreaker fit to the blade was actually really easy. It probably only took 5 minutes to do everything. However, fitting the blade to the plane sole was more difficult. That took about an hour and was a trial and error iteration.

Re: convert transitional jack to panel raising plane?

#27

Re: well, i did it

Lars Parrington

George, I'm not sure what the final angle on the blade was because I never measured it. The angle of the matching groove cut into the sole is 14 degrees. However, the angle on the blade must be different since it is leaned over at 45 degrees.

Re: convert transitional jack to panel raising plane?

#28

Re: well, i did it

Tom

I think this is a real innovation that could prove quite useful. Been watching with interest.