New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Stanley no. 7 issue *LINK*

Posts

Re: Stanley no. 7 issue *LINK*

#26

Re: Send it back for a refund

david weaver

If the frog locks down tight, then the rest of the fettling is just things you need to do to make the parts work together on a plane that probably hasn't been in use for a long time.

It's typical. The only way you'll get a plane guaranteed for an out of the box shaving is if someone was using it properly right before they boxed it up and sent it to you.

Re: Stanley no. 7 issue *LINK*

#27

Re: You were all right

Jonathan Wagner

I'll definitely keep that in mind. I'm sure that at some point, I'll try to get the Hock iron to work and will be forced to file. It's not that I'm against filing, but I did want to make the tool work as is if possible. This tool is over 100 years old and I assume that it worked at one point or it would have been discarded a long time ago. I also have no doubt that if it needed modifying to do proper work as needed by its owner, the original owner probably would not have hesitated. I just didn't want to rely on my own menial experience alone to make the decision. Now that I have it working well enough, I can consider improvements.

Thanks,

Jonathan

Re: Stanley no. 7 issue *LINK*

#28

Re: Send it back for a refund

Jonathan Wagner

Yep, I figured it was an, "it's me, not you" situation.

Re: Stanley no. 7 issue *LINK*

#29

Re: Chipbreaker Problem??

cstanford

Chipbreakers were made with varying degrees of arch. I have an old Record c/b that looks like the Gateway Arch in St. Louis and I've seen many old Stanley c/b's with barely a hump at all. The highly arched breakers can and will cause choking if set close.

Re: Stanley no. 7 issue *LINK*

#30

Re: You were all right

david weaver

With a stock iron it's likely it didn't need work. I can't remember the thickness difference off of the top of my head, maybe 2 hundredths of an inch? If the mouth opening is a couple of hundredths on a stock iron, or the clearance for the cap iron is something like that, then you'll have to modify the plane to work with the replacement iron later.

It is, of course, just fine to use it as it is now and wait until later to do that, you'll be more comfortable doing it if you need to.

Presume this is one of the older types (i've only had to ever file the older types with the milled face frog)

Re: Stanley no. 7 issue *LINK*

#31

'Bout the same . . .

Steve Mackay

I stuck a feeler in there and got 0.130 (+/-). Are we sure that the frog isn't stopped in front of that center "ramp" mount on the body when it should be riding on top of it ?