New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Black Box

Posts

Black Box

#1

Michael Donaldson

Black Box

Michael Donaldson

I wanted to make a larger box than I've previously done, so I got some crap pine boards from the home store (Menard's for those in the part of the world that has those), and made a 2' x 1' x 1' box. This is my third attempt at hand cut dovetails, and my first ever raised panel lid.

For the dovetails, I used a suggestion on this forum, and made a jig with two parallel edges that goes over the board (I made the jig adjustable for different sized stock). This really helped with both the sawing and chiseling.



I am happy with how the dovetails came out.



The lid is just miter joints because they were easy to make. Unfortunately, they fell apart when I was trying to put the hinges on, so I had to figure out how to strengthen them. I used my brace to two holes that pass about two inches across the miter. Then I glued dowels into the holes, creating some cross-grain braces for the lid. So far so good. (next time, it will be mortice and tenon)



Here is the box (without the lid on) before I dyed it.





I recently got some wood dye so that I could try to pop the grain on some curly maple for my next project, and figured I'd give it a test run on this box. With the big dovetails, and rough lumber, I think the rustic look would be cool. It kinda looks like I just pulled it out of the fireplace, but hey, its a practice box.


Re: Black Box

#2

Young Sir you are comin along


Re: Black Box

#3

Nice work *LINK*

Bill Houghton, Sebastopol, CA

I'm fond of feathers/splines on mitered joints - see link below. This link shows splines with some thickness, but you can do them as sawcuts, with sawcut-thick wood glued in, too. The thin "splines" are the origin of the British term "feathers," as the wood's pretty feather-like.


http://www.craftsmanspace.com/knowledge/construction-of-a-miter-joint-reinforced-with-a-feather-spline.html

Re: Black Box

#4

Jack Guzman from Maine

Half-lap miter

Jack Guzman from Maine

Nice work Michael. I also like the splined miter. Another option for joining miters is the half-lap miter joint. Pretty easy to make using hand tools and quite strong.---Jack

Re: Black Box

#5

Dovetails look great


Re: Black Box

#6

James Pickering

Re: Black Box

James Pickering

Very nice dovetail joints, Michael.

James

Re: Black Box

#7

Re: Black Box

Don Stephan

Great work! A couple comments I wish I had heard early on . . . Miter joints of widths greater than 3 or 4" tend to open at opposite ends seasonally due to movement. And a solid wood bottom will expand and contract seasonally (cross grain) while the ends of the box will not (long grain). Really like the symmetric knots on one long side.