Re: additionally.....
Tom
"Studies at VA Tech have shown that this hysteresis also occurs for KD wood. Wood dried below its equilibrium moisture content will not regain to the original value, which, is one reason why KD wood is more stable."
I'm not too sure what that means. Any wood dried below ambient, and allowed to sit in ambient, will not regain it original wet. It may well be that it will not return to ambient even. Since there is often some efficiency loss in processes. It certainly will return above the pre dry level if you toss it in the lake.
As one paper on hysteresis mentioned, "finishing treatments can reduce strongly the accessibility to the material, and thus the moisture buffering capability of wood". In other words, who cares. In the real world finish trumps the wood, and the effects of different processes on hysteresis are marginal at best. Which is not to say that the effects don't exist. My point is I don't trust these studies because they are meaningful in context and nonsense outside of it. When it comes to tossing wood in the water, epoxy is a really good idea, when it comes to say guitars where the concept is an unfinished interior is better than a finished one, you better practice environmental moisture control.
"Modern kilns in the US always over dry wood and then steam back to a 7% target to relax stress."
That sounds painful...
" In my years of experience selling, lumber dried this way doesn't regain above 10% under typical E. TN conditions in an outdoor shed. The other reason KD wood may be more stable is that often air dried wood has not been dried to its equilibrium moisture content of living conditions to begin with."
Why not? air drying does not mean stacked in flitches out of doors, in means air dried. I have places that probably hit 140. And if I bring the stock into the house it will pop back up to the prevailing conditions.
One of the problems with the science types on this board is you don't have a process in either kiln or air drying that is in any way defined. Or a post drying condition, or use. So why even talk about? It is 100% nonsense.