New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

leveling the desk top

Posts

Re: leveling the desk top

#26

valid point, however......

Bill Tindall, E.Tn.

The information I got from Keys lead to success and the information you provided didn't. Fault of the student or fault of the teacher?......Depends on who is judging.

Re: leveling the desk top

#27

Re: watch the shaving

david weaver

when it's straightened out a little bit ejecting from the plane, you're at the point where it's doing maximum work. You can usually back off of it a tiny bit from that, but if the chip is straightening, you'll have a hard time creating any tearout in any quartered wood that can be planed at all.

Re: leveling the desk top

#28

Just my opinion...

Wiley Horne--So. Calif.

Hi Bill,

In regard to the ebony string, I think less is more here. The figure of the center field is very fine and detailed in overall appearance. Lots of fine grain lines, set off by the curl. I think a fine string might be best, or at least worth a look on your part. Like 1/32", but not over 1/16".

This is only my imagining from 3,000 miles away, but suggest lay one thin string down there, just to see....

Wiley

Re: leveling the desk top

#30

Diddling with string

Bill Tindall, E.Tn.

I have seen a picture of a desk top made from some fine grained wood and it has a bold string and looks good. I was thinking 1/4". So I started diddling with string pieces laid on the top. On my, 1/4" was way to big. Even 1/8 was too big. After lots of diddling I have settled on 3/32". Smaller gets lost in the pattern. My vision is for the string to be obvious.

But, with your concern I will revisit the situation before I cut it, which with luck will be later today.