New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Mortise chisel recommendation

Posts

Re: Mortise chisel recommendation

#26

Re-setup my 6mm oire nomi

Tony Wilkins

Followed Wilbur's directions from his blog to a T and got a nice mushroom on it this time. Still not sure it's that comfortable to me - especially beside my Blue Spruce bench chisel and wood is good urethane baby-bumper mallet. Worst part for me is hitting it with the gennou - is it possible I'm doing something wrong?

Re: Mortise chisel recommendation

#27

Re: Re-setup my 6mm oire nomi

Tom

I use a 30 ounce urethan carving mallet. I will use hammers also. A lot of my decision is based on the noise factor. Hammering chisels will ruin your hearing, So I take precautions. Apparently what damages hearing is decibels, and the extent of the high energy pulse. People tend to ignore high decibel short duration or enormity pulses, but over time they are damaging none the less, plus I just don't prefer the noise. So theoretically the decibels of a 22lr is around the same as a framing hammer hitting a nail, but it just isn't a very large amount. So people tend not to notice it. But it is above the safe threshold.

It's a little hard to explain, but imagine a hammer does create a damaging noise, if you could hit two hammers at the same time with each hand, it would have the potential of causing more damage, but one would not tend to be overly concerned.

I have traditional pig sticker chisels, antiques, and they don't seem to be that heavy, there are lots of heavier chisels. I don't know about the RIs.

Re: Mortise chisel recommendation

#28

Re: Re-setup my 6mm oire nomi

Tony Wilkins

Here's what I ended up with after I redid the hoop and mushroomed the end...

Re: Mortise chisel recommendation

#29

Re: Re-setup my 6mm oire nomi

wilbur

Glad my chisel hoop set up article was of some help.

Can you be more specific about what it is that is uncomfortable when you hit your Japanese chisel with a hammer?