New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

Cutting table legs with Japanese pull saw....

Posts

Cutting table legs with Japanese pull saw....

#1

Cutting table legs with Japanese pull saw....

roger lance

Many years ago, I was working for a social agency that bought a house for a counseling center and I happened to find a wonderful piece of 3/4" thick glass with an ogee edge in the basement. I bought the glass from the agency and built a table that my wife and I used in our kitchen. I made use of an Oriental pattern we found at a restaurant. I'm afraid that the table is not well made....this happened long before I knew the first thing about making furniture....no mortise and tenon here. Now, I'm looking to cut the legs down to make a coffee table....


hope she holds together..... :(

Re: Cutting table legs with Japanese pull saw....

#2

you need more work.....

Bill Tindall, E.TN.

The pattern under the glass is attractive, novel, just pain neat. It would be the first thing favorably noticed upon entering a room. The legs....well ugly. You should remake the table with pretty legs. While this might be a bit more work then sawing the legs off the result would be an exceptional piece of furniture.

Re: Cutting table legs with Japanese pull saw....

#3

I would have said

Ron Harper

A little design work on the legs will turn that into a fantastic piece of furniture.

Re: Cutting table legs with Japanese pull saw....

#5

I've always wanted to make a prototype....

roger lance

but making a real Asian corner joint to accommodate a more appropriate leg....well, that's a tall order....will have to think on this awhile....but I must admit, those current legs are crude and ugly.... :D

Re: Cutting table legs with Japanese pull saw....

#6

Just cut the legs IMHO

Denis Chenard in Ottawa

I think the legs won't "attract attention" nearly as much once shorter. Also, going this way means you won't have any differential patina issues caused by work on the legs to "make them prettier"...

At least try that first, if you don't like it then you can always take the next step...

DC

Re: Cutting table legs with Japanese pull saw....

#7

Re: I've always wanted to make a prototype....

TomD

Well, the legs haven't fallen off. Cut them down and bandsaw in (stop cut and chisel), some chinese/Poiroit's mustache action like this:

http://st.houzz.com/simgs/fe5162ed0f3c34eb_4-1813/asian-side-tables-and-accent-tables.jpg

You don't have to go that far, you could simply plane in a little tension on the middle insides of the legs,the outside could stay straightish.

This would be the reverse with the inside straightish, and an "L", not a "C". but it gives an idea of how to use a log:

http://slowoodworker.files.wordpress.com/2010/07/teak-coffee-table_0007.jpg

This is a Krenovish leg, but since it spreads out, and is asymmetric, it ends up looking Japanese. Like one of their castles. But if you want the Chinese look, just apply that approach to the shape in the first pic .

http://www.finewoodworking.com/uploadedimages/Fine_Woodworking_Network/Image_Resources/Magazine/226/011226100_japanese-lattice-cabinet_md.jpg

Re: Cutting table legs with Japanese pull saw....

#8

Re: Just cut the legs IMHO

david weaver

I agree - cut them. They might look right thick like that when they're shorter.

I'd rather them thick and underdeveloped like that than overdone in some tasteless way.