New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Two small projects done today

Posts

Two small projects done today

#1

Two small projects done today

Ron Harper

The clock is part of my work for the Paul Sellers on line class. The marking gauge is curly maple and ziricote


img

Re: Two small projects done today

#2

Re: Two small projects done today

Denis Chenard in Ottawa

Looks good!

What's the deodorant for? Working up a sweat? :D

DC

Re: Two small projects done today

#3

A "no sweat" project?

Bill Tindall, E.TN.

Could we have a picture of the end of the marking gauge showing how the point is attached. This design has great utility for Line and Berry inaly. One can see where the point is cutting in great detail or use it for string cutting. It has the same benefit for marking.

Re: Two small projects done today

#4

Very low tech

Ron Harper

The cutter is a blank for a scratch stock. Has a hole in the middle. Bored small pre drill in end of arm. Small wood screw thru small washer thru hole in cutter. Might do insert later if it looks like I need to.

Re: Two small projects done today

#5

Beeswax


Re: Two small projects done today

#6

Re: Two small projects done today

Patrick Gibbons

I like both of these. I would think an insert is necessary in the gauge just because it's in end grain. In the picture the ziricote looks black. A nice looking wood.

Re: Two small projects done today

#7

Re: Two small projects done today

Ron Harper

Patrick,

It is a very dark wine color. A few coats of BLO darkened it just a little. Not enough light to show the true color.

I really do think you are right about the insert. I did not have one small enough. The closest place for me to get one is 50 miles away. It is on the "to do" list.

Re: Two small projects done today

#8

Not quit 50 miles.....

roger lance

but you might try Rockler from this site (free shipping).

Re: Two small projects done today

#9

Thanks

Ron Harper

I am a tool store addict, and much prefer going there live and in person.

Re: Two small projects done today

#10

One solution Ron

Patrick Gibbons

One solution would be to install a dowel cross grain on the stem. Then the screw would go into cross grain rather than end grain.