New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

Material for veneer hammer "blade"

Posts

Material for veneer hammer "blade"

#1

Jack Guzman from Maine

Material for veneer hammer "blade"

Jack Guzman from Maine

I am making a veneer hammer and I have doubts about the best material for the blade,or the piece that is inset into the working edge. What I have for options is brass, bone,boxwood,plexiglas or uhmw plastic. Any recommendations?---Jack

Re: Material for veneer hammer "blade"

#2

Stephen Shepherd

Re: Material for veneer hammer "blade"

Stephen Shepherd

If you use metal brass/iron/steel you can warm the blade to help with the process of hammering the veneer down. I have made one with bone and one of boxwood and they both worked well.

Stephen

Re: Material for veneer hammer "blade"

#3

Re: Material for veneer hammer "blade"

TomD

I made mine out of brass. The theoretical advantage is that it draws the heat out of the veneer, which helps set it. Though, given the fact my strap was about 1 inch wide, there is not a lot of mass there to really conduct heat away. Worked fine for me, just can't say how much better it would work than something else.

Some techniques involve applying glue on the surface that one then works with the hammer,and I suppose one can have glue at joints or edges. In those cases I would think it was easier to clean, and less likely to get glued to the work, if one had a non-porous material at the edge.

Re: Material for veneer hammer "blade"

#4

Re: Material for veneer hammer "blade"

William Duffield, between Lake Dexter & Lake N

I make mine from brass, too, usually 1/8" thick by 3/4" or 1" wide. You need to round over and smooth the working edge and its ends too, so you don't scratch and mar the veneer. I usually polish it out to 600 grit SiC paper, but that's probably being a bit obsessive.

Bob Rozaieski avoids some of the round over work by folding his brass over (like the spine of a back saw), leaving a naturally rounded working surface. For that, though, you need annealed brass.

Both Stephen and Tom are right about the thermal properties of the brass. (It's kind of like the old Thermos bottle quandary: How does the bottle know you want to keep it hot or keep it cold? :

Re: Material for veneer hammer "blade"

#5

Jack Guzman from Maine

I went with brass

Jack Guzman from Maine

Seeing I had a nice piece of 3/16" brass plate I used that for the blade. 1" wide with 1/2 of that exposed. I rounded it over and smoothed it to 600 grit. The head is hickory and the handle red oak.

Thanks for the good info. ---Jack

Re: Material for veneer hammer "blade"

#6

Good lookin tool, Jack


Re: Material for veneer hammer "blade"

#7

Jack Guzman from Maine

thank you