New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

I'm looking for a source for clamps *LINK*

Posts

I'm looking for a source for clamps *LINK*

#1

I'm looking for a source for clamps *LINK*

Bruce, a MN Galoot

specifically, relatively light duty clamps like these, only a bit bigger (these are available from Japan Woodworker, and I have two):


more like the ones shown in the video, starting at 4:38 or so.

Anyone have any ideas? Thanks.


A true master at work

Re: I'm looking for a source for clamps *LINK*

#2

Re: I'm looking for a source for clamps

roger lance

Try Lee Valley for mini brass bar clamps.

Re: I'm looking for a source for clamps *LINK*

#3

I bet you could make them... *LINK*

John in NM

Of course it might not be cost effective compared to buying them, but you'd definitely have bragging rights :D


brass

Re: I'm looking for a source for clamps *LINK*

#5

bingo !!....


Re: I'm looking for a source for clamps *LINK*

#6

not quite *LINK*

Bruce, a MN Galoot

I should have been more specific. I have two of the 12" brass clamps, from back when I was into making miniatures. I am looking for the steel version of those, a bit heavier and bigger. Turns out they're available from Dieter Schmidt and they cost €53.5 each or $68+ plus shipping. I was hoping for something a bit more local and cheaper.

Maybe I'll have to follow John's suggestion and start making my own. :)


steel hatagane

Re: I'm looking for a source for clamps *LINK*

#7

David Barnett

(Message Deleted by Poster)


Re: I'm looking for a source for clamps *LINK*

#8

the temptation to make my own is strong

Bruce, a MN Galoot

Is that square or rectangular W1 widely available? I can't find it at the local Fastenal.

And short of drilling a hole and squaring it off with files (since I don't have a broach) do you have any recommendations for making that square hole?