New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Electric Tool Must Haves?

Posts

Re: Electric Tool Must Haves?

#26

Re: Electric Hand Planers!!

Joe shelton

I do, and it's great on big, wide stuff. And there's more "pushing" entailed than you might think.

Joe

Re: Electric Tool Must Haves?

#27

Isn't this the hand tool page?


Re: Electric Tool Must Haves?

#28

Re: Can you direct me to the electric page?

Bruce McCrory

Couldn't find the foot forum ... err, electric forum.

Re: Electric Tool Must Haves?

#29

Don't know perhaps messages


Re: Electric Tool Must Haves?

#30

Re: My apology

Bruce McCrory

I am sorry, "Messages" may be a better place for the subject of necessary electric (power) tools.

I think I would have placed the post here, in Hand Tools, anyway. The intent was to extract a "minimum" requirement. Who better than hand tool people to respond to and acquire a "must have" list.

The reason does not include my heretofore ignorance of the general "Message" list. ...

Of course not. ;)

Re: Electric Tool Must Haves?

#31

Re: My apology

William Duffield

No reason for an apology, Bruce. If you ask over on the Messages forum, you might get a plethora of responses like "keep all of them!" or "you only need power tools," or "18 v. is better than 14.4 v," which wouldn't help your quest one bit. I'm being a bit melodramatic--they're really a lot more reasonable than that, but there are some other power tool forums where that's the sort of answer you would expect.

And then, there's the NYW episode, in which Norm built the iconic Shaker candle stand, and actually bragged that the only hand tool he used was a box cutter. I could forgive him for using a pneumatic brad nailer for holding a case together while the glue dried, but I couldn't forgive that one.

Re: Electric Tool Must Haves?

#32

Did you notice how many responses

Bruce, a MN Galoot

you got about electric tools on the handtool forum? There are a whole bunch of us, I'll bet the vast majority, who use both. The "tailed apprentices" do the grunt work and the hand tools refine the grunt work and make it fit right and finished.

You could post over there if you want a different set of responses, but they will be different and you won't get some of the posters here who don't venture over to that side.

Don't apologize!