New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Price drop on over 1300 Rockler items

Vise for cutting tenon shoulders *LINK*

Posts

Re: Vise for cutting tenon shoulders *LINK*

#26

I'll give that approach a try

Bill Tindall

The problem is that a M&T joint needs to be precise to just +/- a few thousandths of an inch to be "right". Hence, it is particularly demanding of any "production" method of achieving it as opposed to hand fitting.

I cut the tenon cheeks as you describe. I have spacer blocks for the tenon jig that match the width of all my mortise chisels and bits. Precisely cutting the tenon thickness is therefore reliable.

I have been using a marking gauge set to the tenon depth to scribe the shoulders in the rail pieces. I cut almost to the scribe line with a band saw and then pare to the scribe line. The paring is fast if the band saw cut is close enough. For a few tenons it may be faster than setting up the table saw for the technique you described. But I will give what you described a try next time.

Re: Vise for cutting tenon shoulders *LINK*

#27

Draw bore

Ron in Kokomo

Yes Bill I still want to improve my skills at this joint. It was so very much easier with a router because the tool and jigs made up for insufficient skill. BUT even when my skills get to the "pretty doggone good" level I am gonna draw bore at all times possible. Takes so little extra time for such tremendous added value.

Several of the icons of the craft have said for years that the dovetail is easy compared to this joint.

Ron

Re: Vise for cutting tenon shoulders *LINK*

#28

Re: Production tenoning

Bruce, a MN Galoot

That's exactly the method I use, too. Although my tenoning jig is homemade and not a cast iron production model, I can cut tenons to any desired precision, from piston fit to sloppy :D