New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Bridle Plough Plane

Posts

Re: Bridle Plough Plane

#26

Re: Bridle Plough Plane 

Paul Dzioba

Derek,

That is an exceptional plane. Just one more thing you need to add to become a full fledged member of the ROPPM (Royal Order of Plow Plane Makers).



Regards from New Jersey,

Paul Dzioba

Re: Bridle Plough Plane

#27

Re: Bridle Plough Plane

JDK

Beautiful work. Congratulations.

I (as many others have here so expressed) deeply appreciate the time you take to catalog your progress with photos and commentary. Your contributions to the woodworking craft are important and will be long-lasting.

Bravo!

Re: Bridle Plough Plane

#28

Thanks

Derek Cohen (in Perth, Australia)

Many thanks for all the kind words.

I must admit that I am am pleased with my efforts here, mainly as it was a personal victory over the fear of screwing up (constantly!).

As I was nearing the end of the build, working on the fence - with the body perched on top of a box on the bench - a hollow plane flew out of my hand (don't ask) and knocked the plane crashing to the floor. I stopped breathing for about 10 minutes. I was certain that the plough would be in several pieces. But amazingly I could not see any damage.

Later, when I was taking the photos, I found the point of impact. On the handle/tote there is a small nick - however it resembles the grain, so it would not be seen in a photo. It can be sanded out, but I think that I will leave it in as a reminder not to be so complacent next time.

Back to building furniture.

Thanks again.

Regards from Perth

Derek

Re: Bridle Plough Plane

#29

Re: Thanks

roger lance

At least, you did not mount the blade bed backwards !! :D .

Re: Bridle Plough Plane

#31

No

roger lance

Actually, you have more than "lived that down"....you were just being very honest and open....its just illustrative of what can happen when your mind is distracted....and for me when I'm distracted, the results are almost always negative....I just don't show it....but it sure happens.

Re: Bridle Plough Plane

#32

Re: Masterpiece...  and yet

TomD

As much as this is a masterpiece, I think in the bigger picture this style of plane offers the option for simpler construction as the moving fence pieces are not in the body of the plane. It reduces the risk. The main barrier I was feeling was just how difficult, expensive, and time consuming machining the brass was going to be, but if one can cut that out of a chip of wood, so much the better. Further, it is easy to mount the spars with compression fittings, and alignment would then be automatic, though that might seem like cheating. The there is the whole fact that it could be seen to be a better operating version of the type. Scores!

Re: Bridle Plough Plane

#33

Re: Masterpiece...  and yet

Derek Cohen (in Perth, Australia)

Hi Tom

The main barrier I was feeling was just how difficult, expensive, and time consuming machining the brass was going to be, but if one can cut that out of a chip of wood, so much the better.

I built three sets of arms when designing the fence system. The second set did not use brass channels, but went wood-to-wood (as with the Mathieson original) ...


I just liked the brass! :)

Further, it is easy to mount the spars with compression fittings, and alignment would then be automatic, though that might seem like cheating.

The brass channel is a compression fitting. The downforce into the corner is what secures the arm and locks it square.



Regards from Perth

Derek