Saw handle slot is cut!
Bob Entwisle in NJ
The saga continues.
In a nutshell, Derek's ( and several others) clear description of jigging the saw blade to cut the slot is what I did and it worked very well.
In fairness to Gramercy tools, Derek’s method is exactly what they recommend in their instructions.
I think what headed me off on a wrong track is that the original Gramercy kit, according to the instructions that are available online, came with the sharpened saw plate, the back (separate from the plate), and the saw nuts.
The online/original instructions show the plate with several small holes in it, (hidden by the back after it is attached) that were meant to be used to attach the plate to a 'jig board' that could be used on a flat surface to saw the blade slot.
Once the blade slot was cut, the back was attached to the saw plate via a process of whacking on the toothed edge of the plate with a softwood bat to set it in the pre-folded brass back.
The current saw kit (at least mine) came with the plate already attached to the brass back. So: (here is where I managed to think myself off track)
1) “Well, at least I don't have to beat on the teeth with a bat to set the plate into the back.” This seemed like a good thing.
2)” But, I no longer have a convenient flat saw plate with screw holes to attach it to a jig board to use for cutting the slot.” Hmm, but I don’t have to beat on the teeth with a bat…..
The "back attached" instructions that came with the kit show using a narrower jig board to use the backed plate to saw the slot, but the depth of the cut with the narrow jig board is far short of where it needed to go etc. (The jig board is shown as a narrow piece of wood against the plate and below the brass back)
So at that point I deviated from (ignored) the manufacture’s recommended instructions, because:
They have put hundreds, or thousands of these together, but I was putting my first one together, so I knew best
, and attempted to freehand the slot with the backed blade, which of course led to a cockeyed cut at best and as Derek said this caused the plate to want to twist. Luckily I did not even attempt to nut the blade to the handle and the minor twist did not become a permanent feature of the plate.
So this evening, after much thought and a couple of careful measurements, I realized the sides of the brass back were sufficiently flat and parallel to the plate. This allowed me to clamp the plate on the brass back between a sized jig board on the bottom, and a wooden caul on top, down to the table saw top. It took a couple of iterations of planing down the jig board to just the correct thickness, after which, I was able to cut the slot in Handle #2, which looks like a keeper. Just a little more fiddling on the back mortise and I'll be on to shaping the handle and finishing this thing off.
Thanks to all who responded with suggestions as well as the interesting discussion on how commercial saw makers cut the slot in the handle. You all really helped encourage me to get this done.
Bob in NJ














