New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

Weekend report: progress with the bench

Posts

Weekend report: progress with the bench

#1

Weekend report: progress with the bench

Derek Cohen (in Perth, Australia)

Update on the build this weekend.

I did not get as much time in the workshop as I would have liked. Still, there were some important parts completed.

As reported earlier, I replaced the end cap bolts.

Then I stripped the legs (they had a sealer), filled all the nail holes and places where resin had dried and fallen out (this happens a lot with some Jarrah), and then sanded smooth.

The bench was morticed to receive the legs, and the mortice and tenons for the front and rear stretchers were completed. Below is a dry fit. Now it is starting to look like a bench (Australian style - upside down :) ) ...


The leg mortices were really hard work. Each is 3" x 3/4" and 2" deep. I drilled out most of the waste, then pared to fit. Exhausting!

I am pleased the way the figure is presented. For ex-roof trusses, these are striking. These pieces were selected to show.

The stopped chamfer on the legs meant that I needed to match this where the stretcher joined. The legs and stretchers are all flush/coplanar.



Regards from Perth

Derek

Re: Weekend report: progress with the bench

#2

Re: Weekend report: progress with the bench

Hank Knight

Lookin' great! I like the Jarrah, but I'm glad I don't have to work with it. :)

Hank

Re: Weekend report: progress with the bench

#3

Keep the reports coming.....

roger lance

it's really looking good....like the figure in the jarrah....the two woods compliment each other well..... :) .

Re: Weekend report: progress with the bench

#4

Ellis Walentine

Good solution

Ellis Walentine

I suppose the alternative to chamfering the ends of the rails would have been to stop the leg chamfers south of the rails. I've used the term "franked" joinery to describe articulated details, but they are usually in the form of a tenon or dovetail protruding slightly proud. I wonder if the term could be used for this sort of collusion.

You didn't drawbore the tenons, or did you? Or would that be overkill?

Cheers,

Ellis

Re: Weekend report: progress with the bench

#5

Re: Good solution

Derek Cohen (in Perth, Australia)

Hi Ellis

Yep, the plan is to draw bore all tenons. All will be glued as well, with the exception of the leg-top (so it can be removed if ever needed).

Regards from Perth

Derek