New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Sharpening station drawer question....

Posts

Sharpening station drawer question....

#1

Sharpening station drawer question....

roger lance

If I built the carcass as first proposed, the drawers would be about 34" wide. Is that too wide for a shop drawer?? All drawers will be on 100lb full extension slides. But would two 17" drawers be a better design choice as opposed to one wide drawer?? The total proposed height of the drawers is 21"....so three drawers of 4",7", & 10"....or some other combination of heights would fill this dimension. Thanks again.

Re: Sharpening station drawer question....

#2

Re: Sharpening station drawer question....

Derek Cohen (in Perth, Australia)

Hi Roger

I'd go for 2 smaller drawers, even 3 if you can fit them (they do not need to be the same widths). Less clutter and easier finding of items.

Regards from Perth

Derek

Re: Sharpening station drawer question....

#3

Depends

Bill Houghton, Sebastopol, CA

I might do a 34" wide drawer if I were putting heavy tools in it - making it 10" deep and packing it full of wrenches, for instance. But you won't be doing either of those, probably, so I think it should be able to handle the strain.

One thing you might do is imagine yourself working at the station and ask whether you would have to open a drawer while you're in the midst of sharpening; and, if so, whether splitting the drawer into two or more would facilitate your work.

Re: Sharpening station drawer question....

#4

Re: Sharpening station drawer question....

Guillaume Dery

I divvy it up.

1 drawer for stones, slips etc.

1 drawer for files and misc measuring junk

1 etc. drawer (oil, lapping coumponds, loose grit, abrasive sheets)

it's been my experience that for things like this, I never needed a drawer that was more than 12"

Wider actually promoted lack of organization and things bumping into each other.

Actually, a 4th drawer would be beneficial. I think I smell a new base coming up for me when the workshop is done.

1 bank of 4 drawers and one door with 2 shelves to house the grinder and stone pond when not in use...

Re: Sharpening station drawer question....

#5

Re: Sharpening station drawer question....

Curt Putnam

There is also a conversation going on Woodnet about wide drawers. The consensus appears to be that over 30" wide creates problems with wracking - not the weight. Since you have the option and the wider drawer is iffy it would seem the better part of valor to go narrow.

Re: Sharpening station drawer question....

#6

Re: Sharpening station drawer question....

Derek Cohen (in Perth, Australia)

Wide drawers, per se, are fine .. but then their depth needs to be proportional to their width. Significantly wider-than-deeper has a tendency to rack in my experience. Of course, if the drawers are run on metal runners this may be a non-issue.

Regards from Perth

Derek

Re: Sharpening station drawer question....

#7

Per the wisdom of the group....

roger lance

the sharpening station will have at least six drawers instead of three large drawers.