till design questions for ATC
Edward in Vancouver
Actually, I have the shell, skirt, and dust seal done, but still need to work on the lid.
However, since it is now November and I make chocolate for a living, I won't be getting much work done on the toolchest untill after Christmas.
Still, I am thiking a lot and planning on how to design my own till. About 3 years ago I finished a "Gerstner" style tool chest (LV plans), and while it is not ideal for bench planes or saws, it is ideal for smaller tools, particularily lay out tools, hey, I even have one drawer dedicated for band-aids!
So, in the ATC, the whole till-unit is about 9" by 36" by about 11" high. And I was thinking...
What if built a single unit till, with the first inch and half of height as a shallow tray, then followed by two banks of drawers, about 2" high and about 12" wide, giving me 6 drawers, then followed by two full width trays,but the trays are on full extension slides. The whole unit moves as one back and forth, but I have access to the back of the larger drawers on account of the full extension slides.
I understand and agree with what Schwartz is saying abut french fitting drawers, I tried it and it is a p.i.t.a. my combination square would only fit if the head was set at the 6" mark... However, I don't like the idea of smaller tools like dividers and marking guages banging around with other tools. In my LV chest, the smaller tools are compartmentized, but not french fitted, and this works great.
The only two drawbacks I can come up with are, that the slides would be butt-ugly, and that the unit might tip if I pull out both full width drawers at the same time.
Suggestions?




