New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

The Veritas Small BU Smoother - reviewed

Posts

Re: The Veritas Small BU Smoother - reviewed

#26

Re: Reality

Derek Cohen (in Perth, Australia)

Hi James

Great Post!

I can confirm that the LN #3, using the 55 degree frog, will accept the #4 tote. I have tried it out, and have ordered a replacement for my own (I have a broader-than-average palm). In fact, I think that is where the information comes from as I reported on my experimentation.


Great combination, the #3 and 55 degree frog. I think that the narrower planes are a better choice if you are looking at high cutting angles. I have the bronze #4 1/2 as well, and it is a bear with the 55 frog. The blade is too wide, causing too much resistance. It is better suited to a lower angle.

Regards from Perth

Derek

Re: The Veritas Small BU Smoother - reviewed

#27

I'm willing to reconsider, "ET" avoidance

Bill Tindall

Your credibility as someone that builds stuff has caused me to reconsider the #3 for fitting. I have one that is in storage somewhere. I hated its dinky handle and hence never used it. But your post got me to thinking about edge teeter ( for Pam, "ET"). I must admit that I still have problems with ET when shaving the edges of thin stock, like a drawer side edge during fitting. I have problems keeping the plane balanced orthogonal to the side, ET. A more narrow plane, it would seem, would aid the avoidance of ET just as the narrow blade makes lateral adjusting easier.

To that end, I will be finding the #3 and seeing if I can fit a larger handle to it, and wrap finger as described. Should I become a #3 convert I will let you all know.

However, I remain attached to my 19 cfm @ 90 psi compressor and air driven ROS for surfaces. I will admit that it is not restful using it.

Re: The Veritas Small BU Smoother - reviewed

#28

Re: I'm willing to reconsider, "ET" avoidance

James Watriss

Well, use it if it's comfortable. I think if you're used to trying to balance a #5, a 3 will feel more manageable. Or even a 4, if the 3 really feels that cramped. But for really thin stock, if you're still having issues, it may be easier to shoot the edge on the bench, end against a planing stop or bench dog, and using a scrap of plywood to elevate off the bench. Do NOT make a dedicated shooting board for this, your time would be better spent practicing the art of plane balancing.

Re: The Veritas Small BU Smoother - reviewed

#29

Re: Youtube for Clark and Williams planes

TomD

I am just reminded that there was mentione of C&W getting some videos on bench planes up on Youtube. Anything there. I have to admit my search skills may not be up to getting past all the Clarks, and Willams' on YT, and apparently Old Street also.