Re: Workbench with storage?
TomD
There is a lot to be said for under bench storage. Drawers seem to be preferred, while cupboards are good for tailed tools. There are a number of designs out there suggested by shaker benches. The Shaker benches I have seen were often large enough for more than one to work at, and located in the middle of large shops. Many of us work in smaller shops where we are up against a wall, or perhaps 3 feet from one. Many hand tools store very well on walls, and the wall is the best option. During work, the base may get obstructed by workpieces or clamps. Also many of us have moved, and want a more easily broken down bench. Another preference some have is to have a tool box of traditional form for their bench tools, this allows one to have ready access, but not to be tied to a wall or bench.
Another solution can be to use the walls, but also the bench for longer term or awkward storage. My bench has trestles under it with long deep aprons, and these have a shelf between them that can hold a lot. I also have a shelf over the trestles. It still retains the look of the open base, but has a lot of storage, and I can easily grab larger planes.
Another version of that is the German tilting chest, that I must say intrigues me:
http://www.wood-shop.co.uk/shop/ECE_Underbench_Tool_Drawers
- Be sure that the overall weight will not move, and cause all kinds of rattling and tool joggling. Not normally a problem but the bench in the pic is on the small side.
- Benches should be 7-8 feet long if at all possible, and even if the full length may not always be accessible. Most benches need to be larger than the largest piece of wood that will go on them. With the furniture modules we have that can easily be 6 feet. Yes many people are very happy with their smaller benches, though I never was happy with my 5 footer. In the overall picture I would trade a lot of other fancy stuff for more size.
- You may well find that your commitment to hand tools gets larger as you go along. Particularly once you get the bench. Don't get me wrong I use a variety of tailed tools on my bench, but normally for as little as possible. I have dozens of small and stationary power tools, but I do not mix them as much as one might think, with my hand tools. There are all sorts of reasons from cleanup, to space, to the fact I get better results with the hand tools at times. As well as the reverse. Therefore I would go all out to serve the hand tools, the power tools will work well on a hand tool bench, while the reverse is not always true