New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

slip installation

Posts

slip installation

#1

slip installation

Bill Tindall


I was inspired by other's slips, but I dislike making tenons. I have avoided the need for one to align the slip with the drawer dado by employing a trick I was shown for aligning the front and side of a drawer for dovetail marking of tails to pins (Headley shop). Just insert a small block the thickness of the drawer bottom. It then becomes a simple matter to align the other end of the slip's dado with the bottom of the drawer back. A slight amount of slip overhangs the bottom of the drawer side that is then readily planed off to be even with the bottom of the drawer side.

I remain challenged when planing a narrow edge to keep it orthogonal to the side. Maybe doing a few drawer slips will provide practice that will lead to perfection.

Note to color of the gauge block. I recycled a drawer for a camping cabinet made in the early 70's. Amazing how the poplar darkened over time.

Re: slip installation

#2

Looks good & simple alignment too.


Re: slip installation

#3

Re: slip installation

Sgian Dubh

It's an old trick Bill, but a good one. I usually use it even when I put a tenon on the front end of the slip. I slide the tenon in place and pop in a piece of wood that matches the groove width just to make sure everything is lined up, and slide the alignment aid out after a few light clamps have been put in place to glue the slip to the drawer side. It's a useful technique because it's always possible that a tenon has been cut slightly too thin. [Edit to say, removing the alignment aids prevents them sticking in the corner, which they sometimes do, and it's a bit annoying to chisel them out later!] Slainte.

Re: slip installation

#4

well done Bill