New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Drawer pull placement

Posts

Drawer pull placement

#1

Drawer pull placement

Bill Tindall


The pulls are paper cut out copies from a catalog. The question is spacing. Books that have pictures of 3:2:1:1:1:1 drawer pattern center the pulls on the top two rows of drawers and then locate the single drawer pulls in line with the double drawers. It looks a bit odd to me but acceptable.

Can anyone think of any different arrangement to try.

The bow front acts as a lens and I have yet to get a good reflection-free picture of this piece.

Re: Drawer pull placement

#2

Re: Drawer pull placement

Bill Houghton, Sebastopol, CA

Seems like the one-drawer pulls should line up with something, and that lining them up with the top outer drawers would leave them too far apart for anyone but basketball players to reach comfortably. So I'd go with what you're proposing.

Re: Drawer pull placement

#3

How wide and tall is it?

Pam Niedermayer - Austin, TX

Re: Drawer pull placement

#4

Re: Drawer pull placement

Robin Corell in Atascadero CA

I think your headed in the right direction with the side to side positioning, but to me the pulls look too low on each drawer. I would suggest playing around with the paper cut outs and try placing them so there is the same amount of drawer above the backing plates as well as below the bails.

The first impulse is to drill the holes in the center of the drawer but ballance usually dictates just slightly above center. If you take a blank sheet of paper and without making any guide marks or meausuring and just by eye place a dot in the center of the paper most people will place the visial center slightly above the center line.

What this means is that often placing a detail like a drawer pull in the exact center makes it look slightly lower than center.

Robin

Re: Drawer pull placement

#5

Re: Drawer pull placement

Stuart Johnson

I agree with Robin the pulls look a bit low. I appears the right side of the second level drawer pull lines up with the left side of of the pull above it. If that is so and the double drawer pulls would be too far apart to keep them in line then try lining up the right pull with the center of the one above. Of course the other side is just the opposite.

Re: Drawer pull placement

#6

Moses Yoder

Re: Drawer pull placement

Moses Yoder

My high school shop teacher told me on a stack of drawers the top pulls at eye level should be in the center of the drawer, then each drawer below that the pulls should be 1/4" higher above center. So the 3rd drawer down would be 1/4" above center, the 4th would be 1/2", etc. That is because as you are standing in front of the drawer stack they will all appear to be centered, and if you are standing a distance away it still looks good. Plus, on the larger drawers at the bottom they are actually a little easier to open and close with the pulls close to the top rather than right in the center.

You do mention the overall height of the pull being centered, which would be the correct way to do it rather than centering the holes.

Re: Drawer pull placement

#7

Re: How wide and tall is it?

Bill Tindall

53" x 37"

A search of recent auctions turned up numerous 3:2:1:1:1:1 drawers. Every pull pattern has been used. However, lining the single drawer pulls up with the top row looks the most strange. Surprisingly, centering the top two rows and then spacing the pulls on the single drawers in between the pulls on the top drawers looked good. But most common was to align the single drawer pulls with those of the double drawers.