New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

Basic question on new tool preparation...

Posts

Basic question on new tool preparation...

#1

Basic question on new tool preparation...

roger lance

what would you recommend for removing the protective layer on a new tool before honing ?? I'm under the impression that lacquer is usually used to coat new chisels and some people have said a soak in acetone is the method to use to remove it. I'm using water stones so I'm trying to avoid gumming them with the lacquer....I guess if I were doing scary sharp, I could just go directly to sand paper....so what say you ??

Re: Basic question on new tool preparation...

#2

Re: Basic question on new tool preparation...

Bruce, a MN Galoot

I've done both but soaking in acetone is easier and I'm lazy. :D

Re: Basic question on new tool preparation...

#3

Re: Basic question on new tool preparation...

wilbur

I use lacquer thinner.

Re: Basic question on new tool preparation...

#4

Re: Basic question on new tool preparation...

TD

Unless you don't have the stuff around just try wiping something on them. I have used alcohol with success, and fall back on acetone if require.