Two additional points
Bill Houghton, Sebastopol, CA
Before you begin, block at least one and preferably both wheels on the end you're not raising up with chunks of 4x6, concrete, etc., to keep the wheels moving in either direction. If you're on a significant slope, blocking the downhill side of the wheel is OK; but if you're on the level, block both ends. If in doubt, pretend your front yard is level.
After you jack up the the end/corner of the vehicle from which you're removing the leaf spring. support it well. No concrete blocks (limited strength in shear), no cheap jack stands from your local Dollar Store (I once had a set of those fail right AFTER I'd crawled out from under the car; in an alternate universe, where they failed while I was under the car, I'm not typing this message). Good jack stands are OK on sound, level concrete or asphalt*; but for a front yard, you want 12" long** chunks of Doug fir or similar 2x6 or 4x6, in sufficient quantities to lay them up in twos, side by side, alternating directions with each layer, under a frame member or sound portion of the body (on unibody cars). It's ok to have just one on the last layer if you need the clearance.
Always stand at one end of the car and shake it back and forth vigorously after you've supported it and before you remove the wheel(s). This will tell you if you've done a good job (the most obvious test failure is when the car falls off the blocks, but obvious rocky-back-and-forth motions aren't a good sign either).
*Except in those parts of the country, like the South and parts of the Midwest, where summer temperatures are enough to soften asphalt, causing point loads to sink into it. Like, say, side stands on your first motorcycle, in July, in Detroit. For instance.
**Longer is OK, up to a point, but can get in the way.






