No regrets here.
Pam Niedermayer - Austin, TX
Knowledge You Can Build On — Est. 1998
No regrets here.
Pam Niedermayer - Austin, TX
Re: Thanks, Wilbur
wilbur
As far as the blade being "too hard", it's not uncommon for a Japanese plane blade to hit RC 64-65. I would say that as long as you have something that can sharpen it, it's not too hard. 
Re: Thank you for the kind offer - truth about woo
ThomD
I don't insist of paying for them... 
Quite understand.
And as usual I am way ahead of the likely output. Didn't I just post something about cutting a ton of beech wood for planes! Funny though I have not really had much in the way of dai wood since the seminar. Made some Japanese style planes, including the beech western style one, and that seems to work fine. Maybe there is a bow limb like rule at work here - as long as the material is adjusted for thickness relative to weight, it works fine. I have made Japanese planes out of a lot of oddball woods over the last 40 years. But it did seem like a compromise when I stuck to western woods. This beech one was much more satisfactory, and beech is relatively soft. Could be the difference is the depth of the blank, which is not anywhere near the depth of a western plane, but higher than a Japanese one.
Re: Thank you for the kind offer - truth about woo
Pam Niedermayer - Austin, TX
Glad that beech is working out for you, and, yes, I did remember that you have no place to store even 1 dai blank.
Apparently Live Oak is a good wood for Japanese dai, but I haven't needed to get some yet.
Pam, who could probably be convinced to send you one for free if Canadian customs wouldn't grab it, but experience says they will, especially if it's free, real paranoid bunch those border patrols.