Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Blades for side escapement planes

Posts

Re: Blades for side escapement planes

#26

Sorry Larry

Bob Hackett

I probably didn`t direct my post well.

My suggestion was not aimed a you it was aimed at those at home who may see your contribution to this thread,see the need for the increased striking area and may want to somehow incorporate that idea into their home brew irons.

I completely understand that the cost of adding extra steps,not to mention an extra process to an already tooled up system is pretty much the opposite way from where your company wants to go even in a limited production type of arrangement.

You folks are looking to streamline the process and reduce costs rather than add things for minor gains and complicate something that you have already sorted out.

Sorry for any confusion.

MB

Re: Blades for side escapement planes

#27

Re: a late reply

Thomd

Thank you Larry for your answer.

You are right about my question, probably a couple of things in there. One is the question about how it was done in the past, and whether it is typical of older planes that they had a short steeply tapering section followed by a section that may not even be fitted to the wedge. So that all the wedging action takes place in the 2 or so inches after the edge. And if not what did they do.

Beyond that there is finding some kind of formula to use myself. I have a surplus of ideas there, but the possibility that the originals had not been wedged full length took me rather by surprise. Only having to grind a short section with accuracy would make my job easier and probably allow me to use the mill. To taper full length I will probably use my 2x72 belt sander and a pattern to ensure consistency the full length.

Seems to be something similar afott with the bench planes.