Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

OT - used my circumference rule yesterday

Posts

OT - used my circumference rule yesterday

#1

OT - used my circumference rule yesterday

Bill Houghton, Sebastopol, CA

>Some years back, I picked up a 3 foot Lufkin circumference rule. These have two scales, inch on the top and circumference of a circle with the diameter represented by the inches at that point. The tables on the flip side of the rule make clear that it was a sheet metal worker's tool, as they show such things as contents in gallons of various sizes of cylindrical containers.

During my brief life as a sheet metal worker's grunt years ago, I didn't see any such rule in the shop - but may have missed it. The journeymen I worked for just calculated circumference, as I recall, on the rare occasions that they needed to make a cylinder in anything but the common heating duct sizes (alas, by the time I did sheet metal work, 90% of sheet metal was running ductwork and flashing for building construction; not a lot of scope for creative problem solving).

But I can see, now, the utility of such a rule for someone constantly matching strange diameters; it would improve efficiency a great deal. My epiphany came from making gopher cages so my wife could plant some roses. This part of California has even more gophers than it has vineyards. Our cat thinks this is just great (although she's been a little slack lately in the gopher-eating department), but they chew up the roots of all kinds of plants, including roses. Thus the cages, to keep the little critters away from the roots.

Measuring the diameter of the dug hole and, from a reading of the circumference scale, determining the length of hardware cloth needed, sped the project up a lot.

Recommendation, by the way, for anyone doing this: make cage first; dig hole to fit cage, not the other way around. My approach resulted in using up more than this week's ration of curses.

Re: OT - used my circumference rule yesterday

#2

Re: OT - used my circumference rule yesterday

ThomD

>I figure most cases dividing by 3 or 3.142 will get me there. I can do 3 in my head, the other one would need a calculator.

Re: OT - used my circumference rule yesterday

#3

still available on line around $70

Wayne Carson

>

Re: OT - used my circumference rule yesterday

#4

My $1 at a garage sale looks pretty good, then

Bill Houghton, Sebastopol, CA

>

Re: OT - used my circumference rule yesterday

#5

where have all the "odd" rules gone?

Ian (in Sydney, Australia)

>A pattern maker I know, recons that all the "odd" rules were ditched when pocket calculators became ubiquidus (I'm sure I spelt that wrong)

you just need to store the conversion (for the particular metal) in the calc's memory and there's then the one rule does all.

Sad, as I rather like how an inch on a brass rule is a different length to an inch on a bronze rule

take care

Re: OT - used my circumference rule yesterday

#6

Re: where have all the "odd" rules gone? *LINK*

Robin Corell in Atascadero CA

>they are still available from specialty tool supply houses. Starret still lists them in there complete catalog as well. Not sure how much they cost, the last one I bought was north of $30 for a 12" 5/32 and that was probably 15 years ago.


shrink rules