Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Handsaw Handle Angles - Open Handled

Posts

Re: Handsaw Handle Angles - Open Handled

#26

Thanks for a Great Chart

Ray Gardiner

>Hi Bob,

Hi Bob,

Good to know you are still around, I appreciate the work you did with your (much quoted) page of saw handle hang angles. I never did get to see your saw gallery web site when it was up, and the wayback machine is a bit patchy. So trying to find your site became a bit like searching for the holy grail. Especially the legendary saw handle gallery..(my efforts along these lines are here..http://www.backsaw.net )

It will be good to see your handle gallery back up again someday.

Regards

Ray

Re: Handsaw Handle Angles - Open Handled

#27

raw images

paul womack

>Sadly, these are taken at a jaunty angle, so taking measurements is less simple:

http://www.softorchestra.com/woodworking/tools/saws/handsaws/

BugBear

Re: Handsaw Handle Angles - Open Handled

#28

Re: I don't know, but I wish he was still around.

MikeW

>Fondly remembered, Bob.

I thank you (and your friend for alerting you) for delurking long enough for us to thank you publically.

Our best wishes.

Mike

Re: Handsaw Handle Angles - Open Handled

#29

Re: Handsaw Handle Angles - Open Handled

Paul Kierstead

>A long tenon saw has the lower hang handle because the stock is generally placed high in the vise.

I think Mike nails it pretty squarely there. Not surprising :) I am no saw expert, but do saw things sometimes, and I also note that my distance from the work also varies by saw and task. Longer saws (including back saws) and I stand further from the work. I also tend to stand a little further away for "rougher" operations, probably to aid generating power. This fairly clearly (well, to me) affects the desired hang angle. Tenons on really long pieces (I did a bunch of 7' + pieces a while back) are even more interesting, since you tend to be sawing upwards; a low hang angle would be awful.

One I find interesting is using saws with a saw hook on a bench. I typically use a closed handle saw, but find the hang angle a bit too large since the work is fairly low and relatively close to the user. I also suspect that application would be better served by a different tooth configuration, since you are sawing directly across the stock. But I digress.