Example 1 *LINK*
Wiley Horne--So. Calif.
>Thom and all,
You raise a great question. I like rasps and rifflers, and will show two project examples where I've used them. Both examples have to do with shaping curved details. The rasps were used in conjunction with gouges, small shaves, and scrapers.
A link to the first example is given below. It's a chiffonier, modeled after a Greene & Greene example. In the linked photo, there are three items where rasps and rifflers were useful: (1) the pulls, (2) the projections of the drawer sides through the drawer front, and (3) the raised inlay on the cabinet front.
A big advantage of the Aurious, as Scott Burr points out, is that they are toothed to the edge, and to a point. Which means that the finer ones especially can be used to cut very fine lines and details.
Specifics:
1. The pulls......These are visually simple, but each one is a mound of intersecting convex surfaces. I handsawed the blanks, and at that point they looked like 3 descending blocks stacked on each other. Like an early 70s BMW with a trunk strapped on top. The inner curves were incised with gouges as much as possible. Perhaps an expert carver would have done the whole job with nothing but gouges. However, I found the rasps and rifflers useful because making stab cuts with gouges to define the intersecting convex curves--or even making raking cuts with a skew gouge--would inevitably produce shallow scorings. These scorings were slightly over-deep cuts, so slight I could scarcely see them in the raw wood. But. When the finish hit them, those overcuts jumped out prominently, and were really ugly. The rasps and rifflers were able to almost define these intersections, without any overcutting. The final surface was produced with John Aniano's 'bamboo leaf knife', which was used in scraping mode--and folks, this is a great tool, which he uses in his bow-making business. I'll post a link to it in a separate post. Incidentally, I tried sandpaper in various forms to do bits of the above, and though it was some use, it could not be used to finish the critical surfaces because it smeared the details. Finishing by scraping was the only way, but the rasps/rifflers were vital, because they let you see the object emerge, and you know when to keep going and when to quit (before you ruin the pull).
2. Projections of the drawer sides through the drawer fronts....This was just rounding the front of the projections. I could shave to the control line more precisely with the rasp than with sandpaper. Final surface done with Auriou grain 15; burnished the endgrain with 400g paper.
3. Raised inlay on the cabinet front.....This inlay started life as a series of curving channels, fretsawn approx. 5/32" deep and widths varying from 1/8" to 3/16". Each of these pieces then had to be tooled (prior to being installed in their grooves) to look sinuous, like vines. The flowers and flower buds also had to be shaped. I used gouges where possible, but rasps and rifflers were essential as the inlay pieces became thinner and more refined, because the fine rasp--think grain 14 or 15--would produce a crisp line without putting so much pressure on the workpiece as to split it.
Wiley
Use of rasps--Example 1, chiffonier