Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Shooting for Perfection *LINK*

Posts

Re: Shooting for Perfection *LINK*

#26

Side elevations

Derek Cohen (in Perth, Australia)

>Hi Thom

Fig #1 is a side elevation of the shooting board as it actually is. The plane (represented by the red arrow) runs on the horizontal. This does not meet your preferred design, but the waxed wooden runway is slick, and the work piece is held firmly on the ramped slope.

Keep in mind that the ramped angle here is exaggerated (you think?)

The thought occurred to me that there is a way for the shooting board to work as you envisaged. All one has to do is raise the rear of the board above the bench height. So in Fig #2 one could clamp a board in a face vise and lock the rear agfainst it.



... just having some fun with a little lateral thinking, you understand. :)

Regards from Perth

Derek

Re: Shooting for Perfection *LINK*

#27

Re: Side elevations

ThomD

>In two the plane would still be wedging it's way up under the board. Anyway, the fact it doesn't work as I would expect, just gives me something else to noodle on, it's more interesting that way!

Re: Shooting for Perfection *LINK*

#28

Its about time I made a new one...

John in NM

>I was struggling with my ill-conceived, baltic birch and staples, "temporary" shooting board yesterday. Time to make one like yours. I think I may ramp the plane track rather than the work platform though. I've got some left over lyptus from a door I made, it makes great fence/jig material, being so dense and hard and waxes nicely (sucks for doors I'm sorry to say).

One question though. Is the adjustable fence necessary? Wouldn't it be better to get it right once, then never have to adjust it? I'm thinking of glue and screws, then if it doesn't come out exactly right, adjust a tiny bit with a shoulder plane.

Re: Shooting for Perfection *LINK*

#29

Re: Its about time I made a new one... *LINK*

Derek Cohen (in Perth, Australia)

>Hi John

I've made both fixed and adjustable fences. It is easy enough to make a dead-on fixed fence - just follow my how-to in the link below (it is a full article on shooting boards, so run through it until you find the spot).



The reason for an adjustable fence is two-fold:

Firstly, it is helful when you can move the fence rather than have to use wedges when planing irregular pieces. I find wedges often move and are generally just clumsy to use.

Secondly, over time a shooting board will wear and need to be they planed back to original specs. When you straighten the sidewall of the runway, you will find it easier to square it with the fence if the fence is adjustable.

On quick-and-cheap shooting boards (like one in the article) I would make a fixed fence because it is easier to make a new one than repair it. Shooting boards can be simple to make. However, on the fancy shmancy ones you want to be able to preserve them.



Regards from Perth

Derek


Setting Up and Using a Shooting Board

Re: Shooting for Perfection *LINK*

#30

Adjustable is a double edged sword...

John in NM

>I take your point about easy adjustability for a "permanent" jig like a nice shooting board, but for me its going to be easier to deal with having to plane the fence one day or cut it off and glue on another than to have to fuss with it if it ever slips. On the other hand, I might make it adjustable with a captured screw to bear against rather than a friction held device. Thanks for two great articles Derek - I'm inspired to get to a long overdue upgrade!