This is good news, another tool in the wild! *LINK*
Alan DuBoff
>Todd,
This is actually good, this means there's another of your tools out in the wild.
That little hammer really did show mostly how your filing skills were, but it showed that once an old bolt was wrought, much of it was in the finish. That was a nice little hammer, and I'm sure the recipient appreciates it.
The one area I haven't seen too many people exploit that I think is ripe for ideas, is workbench holdings. Scott Thomas has a couple interesting contraptions, but I think this is one area that hasn't been exploited with the forge, using bench dogs for securing.
The hammers are good also, your hammer was nicer than the Japanese hammers that woodworkers are worshiping like an idol, selling for much $$$s. Whenever I start getting too serious about the smithy, I try to go read the below link at Dieter Schmid, for some reason it really puts some laughter in my day...where this text shows up:
(truly inspiring to any smith;-)
----
"There are many steps in the process of forging a hammer head. But making the hole to take the handle is the most complicated and demanding. First one hammers a small hole most of the way through the red-hot head blank. This hole, which at first does not go completely through the hammer, deforms the head. Therefore the head is corrected again and again as the hole is enlarged. This process is done by sight, by feel and by intuition. Hiroki takes no measurements and relies on a lifetime of experience. If the hole is not perfectly centered, the thin side is cooled a bit with water, and the head is brought with some well-placed hammer blows into balance. Seen first hand, it is a virtuoso performance -- forging red hot steel like a baker forms dough. It is also important to keep sharp interior corners in the hole, so that the handle can be fixed as securely as possible."
----
And there is even a video, in case that doesn't lighten up your day, where you can see the "virtuoso performance" in action. *grin*
Dieter Schmid, Fine Tools (and descriptions)