Re: Thanks! Food for thought.
Charles
>That's a good workaround, but not necessary of you use the proper material to begin with.
Knowledge You Can Build On — Est. 1998
Re: Thanks! Food for thought.
Charles
>That's a good workaround, but not necessary of you use the proper material to begin with.
Re: What about dubbing?
Charles
>I hate to see a quality strop glued down since you've automatically lost the use of half of it.
With a big heavy strop, and both sides, you can charge different areas with different grits, leave areas uncharged, etc.
I personally haven't found dubbing to be an issue, but I sold my electron microscope last year so I can't be 100% sure....
Re: Get some stropping paste first?
Kevin Adams
>Hi Charles--
I've been using the green (LV) and white ("white gold") crayons on leather strops and I do agree that you get a build-up. I have a fresh horse butt strop that I would like to try the paste on now. In doing a web search, I did find the Dovo paste you suggested, but the site seemed to be suggesting the use of diamond paste instead. Here's the link if you're interested:
http://www.classicshaving.com/articles/article/590351/18185.htm
http://www.classicshaving.com/catalog/item/522944/482843.htm
Do you have any opinion on this? I recall in perhaps another thread someone mentioning that diamond paste didn't hold all that well on leather (too soft) vs. something like cast iron, and yet this site says the opposite (use soft wood like balsa or leather). BTW, do you use any sort of dressing product on your leather strop or just apply the paste on the raw leather?
Thanks for your further insight on all this.
Kevin
3M products
Bob Hackett
>Any of thier products for power buffing paints will work for stropping.
I`ve used Finnessit on hard maple and it`s near as effective as diamond paste.It`s water base and comes in a squeeze bottle.one bottle will be a lifetime`s supply for about 6 WWers.
See your local auto body shop for samples(bring ziplock bags to put it in).
MB
Huh? Whadya say?
Patrick Gibbons, Houston, TX
>
Re: Another thing my father likes to say...
ThomD
>"Doubt it will work. According to Bill Tindall, the particles embed themselves in the substrate and don't do their work. Cast iron is the material of choice here, hard enough that the diamond particles don't "sink in" the substrate, yet soft enough that it holds the diamond in place."
That may well be true, but it does seem to give more credit to the surface condition of most plates than I would have thought possible. I wish I could get some tools made to a .25 micron condition.
Now that LV has the stuff I am going to give it a go. What is it designed to do, and to what is it intended to be applied in the real world?